Eddytherm

BEARING HEATER
EDDYTHERM microprocessor controlled Induction Heater for bearings and other objects allows precise setting of time or temperature to prevent premature bearing failures due to overheating. Temperature probe continuously measures and screen displays actual temperature. "Stand by" feature permits holding temperature at pre-set level for an indefinite time. Automatically demagnetizes workpieces after heating. Light and buzzer signal termination of heating/demagnetizing cycle. Three models available. Shrink-fitting bearings, sleeves, sprockets, couplings, impellers, crane wheels and gears, etc., of up to 900 lbs. is made easy, clean and quick.

It is difficult to determine how long it takes to heat gears, impellers, couplings, bearings and other workpieces from ambient to the target temperature for proper shrink fitting. Theoretical calculations are not always reliable, since so many factors such as ID, OD, width, material, configuration of workpiece and weight come into play. We offer you the services of our induction heater lab to conduct tests on your samples. This will guarantee that you can duplicate achieved and documented results in your facilities with the recommended heater and selected crossbars.

Order No. ETH 17.110 EDDYTHERM 1x Package
Suitable for bearings up to 25 lbs. in weight, including magnetic temperature probe ETH 7305 and crossbars ETH 7651, 7653, and 7655. Electric current: 115V, single phase.

Order No. ETH 17.500/2 EDDYTHERM 1-6 Package
Suitable suitable for bearings up to 90 lbs. in weight, including magnetic temperature probe ETH 7305 and crossbars ETH 7652, 7654 and 7656. Electric current: 480V, single phase.

Order No. ETH 17.500/4
Ditto, except 220V

Order No. ETH 17.440/3-60 EDDYTHERM 4x Package
Suitable for bearings up to 900 lbs. in weight, including magnetic temperature probe ETH 7305 and one crossbar ETH 7640 (75 x 75 x 460mm). Electric current: 480V, single phase.

Order No. ETH 17.440/4-60
Ditto, except 600V